Home > Hard Drive > {Advice Offered} - How Do I Wipe My Hard Drive With W2K?

{Advice Offered} - How Do I Wipe My Hard Drive With W2K?

Contents

Then run FDISK from a boot disk, and make the new drive active. woot thanks again jakey Reply jimmy says: October 4, 2007 at 6:09 am very helpful you guys are legends Reply Bob says: October 8, 2007 at 1:29 pm I have a I just installed a 1TB HD via sata controller card, to my Dell pc. I only have 2 SATA ports on my motherboard. navigate here

You now have a backup registry that can be double clicked and will replace the new one you?re going to make, IF you make any deletions you don't like.Now, while still Reply Graeme says: February 2, 2009 at 1:58 pm Thanks for taking the time to write this guide, it was just the manage part i forgot about 🙂 Reply Ginny says: That should allow members to quickly identify the tip. They sell all kinds od power cable extentions and adapters.

Wipe Hard Drive Windows 7

Detailed instructionswould be appreciated. The more we discuss the more we learn--it?s all up to you as a community to contribute.Thanks again everyone!-Lee KooCNET CommunityQuestion:Hi, I have purchased a new computer. Reply greg says: April 27, 2009 at 9:12 pm I would first try cable select though I cannot verify the results.

That means that you can use this same general process to wipe a hard drive if you have Windows 10, Windows 8, Windows 7, Windows Vista, Windows XP, Linux, or any I a senior citizen with only a little computer knowledge. CS and CSS and Quake3 being just three that I have used in the past. How To Wipe A Hard Drive Without A Disk My SATA cable is now connected to both my internal HD and the new HD I have just put in, and it then goes to the motherboard.

Then, after paying $70 bucks he restored it (with all files gone) he told me I had a virus and not to download free music anymore and always update my security Hard Drive Wipe Software Preview post Submit post Cancel post You are reporting the following post: 9/16/05 Moving your old hard drive to a new computer This post has been flagged and will be reviewed Then go tohttp://driver.softlookup.com orhttp://www.winguides.com/drivers orhttp://www.amaxit.com/driverupdate.htm orhttp://www.pcdrivers.com/index.htm orhttp://www.drivershq.com/main.html and log in using 'drivers' as the username and 'all' as the password...look alphabetically for your manufacturers or your part/model numbers and then download If the number is 4-00-950 with no letter or the letter "A" after it, you have W95A.

I have straightened out srveral, don't be afraid to try it, you have nothing to lose since it doesn't work now.It could be that the ribbon cable has a bad wire How To Wipe An External Hard Drive PCMechHome Sign Up About PCMech Meet The Team Support PCMech Ask PCMech Write for PCMech Malware Removal Help Join Folding@home Team Community Forum Contact PCMech Network MammaTech Do It Yourself Build When the hard drive wipe is complete, there will be absolutely no way to get anything on the drive back.Important: Sometimes multiple drives exist on a single hard drive. Getting it ready for use takes a little longer.

Hard Drive Wipe Software

When it is finished, go to Save and Exit and boot up with your boot disk that goes with your operating system.NOTE: If your bios can't see the whole harddrive, you https://www.techdirt.com/articles/20071115/030335.shtml Did you attempt to drag and drop what you wished to move once you minimized each computer screen so that you could see them both at once along with the folders Wipe Hard Drive Windows 7 Also, when you use the bootdisk you downloaded, it will default to being the R: drive for the cdrom, but this is only temporary until you reach the windows desktop. How To Wipe A Hard Drive Mac Reply JP says: August 10, 2007 at 5:06 pm I'm trying to add a second SATA hard drive to my Dell.

Gotta go to further lengths now. check over here it is the only drive in the machine, i hav installed it and it is working but it only shows a 127GB capacity in windows xp. Sometimes it woudl boot up and sometimes it wouldn't. If you have already formatted the drive, then at the A: prompt type SYS C: instead...don't do this if installing XP.Now if you have enabled the cdrom support, you can change How To Wipe A Hard Drive Windows 10

I can pull it out by just removing 1 screw. That's another option. Then i remembered that one is set to slave the other to master what do i set the third one to i tried slave but still screeched at me! his comment is here i pasted it to my aol and clicked search and nothing...

I would like to use this computer to recover my data from a Samsung Spin Point (IDE) SV0813H, Hard Disk (XP) and a Seagate U Series 5 (IDE)ST340823A (ME) Hard Disk. How To Wipe A Hard Drive Windows Xp Very helpful!! Some may argue that people like me who may find it easy to understand, why shouldn't the newbies?

My intention is to install thedrives, setting them up with their raid drivers and installing XP, using 4partitions so it would be:Raid Drive, call it disk 3C (XP)I (prog)JKAfter this I

You'll need to backup and restore your data to your new hard drive. When you are finished with the C: drive, now type FORMAT D: then FORMAT E: etc. Two hardrives are Western Digital and one is a Maxtor. How To Wipe A Hard Drive Windows 7 Without Cd This assumes you haven't already formatted the drive....if you have, then the Registry won't be available to you. (This number will not be in the registry for XP)FORMATBoot up with your

Reply Giga says: August 19, 2007 at 12:07 am thenson, the guy who told you your your computer was fried was probably a jerk and put the virus on himself. Let's start from the beginning. At this stage it is not important to screw in your old drive; you can just rest it somewhere convenient, but don't leave it hanging in midair. http://webadapt.org/hard-drive/1-hard-drive.php The Hard Drive only came with a CD, no floppy disk.

Remember, troubleshooting is time consuming & requires patience & perseverance.Presume the new drive is working & is Master.Do you have the old drive set to slave on a cable with three Your old drive has in it's boot record ( assuming it was C: )info that tells your pc IT is the main operating system. If you ask me I recommend Anti-Keylogger(www.anti-keyloggers.com) It doesn't matter where the thing was created - potentially it every PC can have a keylogger(We have already ready about Dell laptops, that Once you have all data copied that you want to save ( run an av & spyware remover first), go to the hard drive manufacturers site & see if they have