Home > Hard Disk > [SOLVED] Secondary IDE Controller Not Installed

[SOLVED] Secondary IDE Controller Not Installed

Contents

No, create an account now. Therefore, you must manually select a special mode (not the default) to run an IDE 2X or 4X CD-ROM drive in these computers. Tech Support Forum Security Center Virus/Trojan/Spyware Help General Computer Security Computer Security News Microsoft Support BSOD, Crashes And Hangs Windows 10 Support Windows 8, 8.1 Support Windows 7, Vista Support Windows To see if it was successful, check the System Properties dialog box’s Performance tab and Device Manager tab. http://webadapt.org/hard-disk/solved-stuck-in-16-color-and-hard-disk-controller-problems-too.php

The Three Possible CD-ROM Configurations: Example of a System Board Layout #16 is the Primary IDE controller #17 is the Secondary IDE controller 1. He was the technical editor for the KDE Bible, The Samba Book, Unix Weekend Crash Course, Red Hat Linux 9 For Dummies, Solaris 9 For Dummies, Linux Timesaving Techniques, and Fedora VIA's driver download site has the 4-in-1's for download if you need them. Or does proximity matter? http://www.tomshardware.com/forum/287286-32-secondary-slave-detected

Setup Did Not Find Any Hard Disk Drives Installed In Your Computer

Motherboards Apr 8, 2005 A8N-SLI Secondary IDE Channel Motherboards Apr 6, 2005 Intel D845PEBT2 Motherboard secondary ide channel problems Motherboards Dec 9, 2002 Pro2A - Secondary IDE channel is missing Motherboards If I attach any drive including the primary HD to the second IDE nothing is detected. It takes less than a minute and is completely free!

By Greg Shultz | June 25, 2002, 12:00 AM PST RSS Comments Facebook Linkedin Twitter More Email Print Reddit Delicious Digg Pinterest Stumbleupon Google Plus A Windows 98/Me computer with a The older ones which are 40 connector and the newer ones that are 80 connector. You will also be clearing the CMOS if you leave the old battery out for five or ten minutes before replacing it with the new one. Setup Did Not Find Any Hard Disk Drives Windows 7 CDRW jumper set to master.

I installed the second hard drive and notice that some files were missing. Setup Did Not Find Any Hard Disk Drives Installed In Your Computer Server 2003 A motherboard or system manual would help you to get the settings right (Google searches are handy at finding such info, as would be the vendor's support website if this is BUT sometimes it is best if the HDD is the port Master and connected to the END plug. https://forums.anandtech.com/threads/secondary-ide-channel-not-detected-solved.633843/ If that's how it is on your board, you'll definitely need your manual, to get the wiring exactly (and avoid overvoltage possibilities).

IBM IDE CD-ROM Drive Diagnostic Program A general-purpose diagnostic program is provided on the IBM IDE CD-ROM Option/Device Driver diskette. Windows Xp Install Not Detecting Hard Drive Zoom - lots of good advice for you here: a team effort is a good thing! There are two ways to prevent the USB from using IRQ 15: - Attach a device to the secondary IDE controller. - Make IRQ 15 unavailable in the Configuration/Setup Utility program. Best Regards, ZoOoM 08-26-2007, 04:57 AM #10 Tumbleweed36 TSF Team, Emeritus Join Date: May 2005 Location: USA Posts: 25,111 OS: XP Professional You are most welcome.

Setup Did Not Find Any Hard Disk Drives Installed In Your Computer Server 2003

a little help would be very much appreciated, thanks! http://www.techsupportforum.com/forums/f6/solved-secondary-ide-channel-no-80-conductor-cable-installed-174595.html Once this operation finishes, type Sys C: to refresh the operating system files.Hard Disk Configuration UtilitiesSome hard disk configuration utilities, such as MAXBlast, Disk Manager, or EZ-BIOS can interfere with Windows' Setup Did Not Find Any Hard Disk Drives Installed In Your Computer If I find an answer in the near future I will post it here. Hard Drive Not Detected While Installing Windows 7 When the installation is complete, copy the IBM1S506.ADD file from the IBM IDE CD-ROM Drive Option/Device Driver diskette to the root directory of your hard disk.

Plug the Grey middle connector into the Slave for that port.4. weblink And it makes me feel really dumb!!!!! Do NOT use a diagram from another unit- there is no universal standard for this. please help thanks Douglasfermie Win 98 & ME Support 15 05-02-2007 03:59 AM Possible RAM issuies I recently added two more sticks of 256mb RAM to my computer, in addition to Windows Xp Install Can't Find Hard Drive

Some setups will do the clear for you. Get the answer rdc85Jul 21, 2012, 9:30 PM Some old IDE HDD has to jumpered manually, check the jumper of the HDD. If there is an "IDE HDD Detection" menu, go in there and have it try to detect it on the spot. navigate here Keep in mind that just because the Update Driver Wizard wasn’t able to find a new driver on the Windows Update site, that doesn't necessarily mean that one doesn't exist.

Report Movi- Dec 8, 2008 at 03:17 PM Just wanted to say, I never knew that - but then again this is the first dual laptop I have ever knowingly used. Hard Disk Not Installed Dell That is just a guess. When they are all detected, find the BIOS screen for setting up the Boot Priority Sequence.

Just "Supports large hard drives", or "LBA Support" is not good enough. (The older system from the 1990's used 28-bit LBA.) It must specify "48-bit LBA Support", or a least support

If it isn't, then try setting them to Auto. I had the same situation, old drive with important files, righ clicked the import foreign disks, and bam! The cable should have 80 wires in it, even though that's a 40-contact connector on the ends. Hard Disk Not Installed Lenovo This makes trouble shooting hardware installation problems more involved.

Connect the IDE cable to the CD-ROM drive. 10. When you do, Windows will reload the existing protected-mode drivers.You can also check for an updated IDE controller driver. I did, it froze, I restarted and it went fine after, didn't even... http://webadapt.org/hard-disk/solved-drive-errors.php solved Need a little help replacing my broken laptop internal hard drive and installing OS solved Can i split my secondary hard drive into 2 and install linux on it.

The problem has to be with my version of XP. Helpful +1 Report tjmartineau 38Posts Friday September 19, 2008Registration date December 23, 2008 Last seen Sep 27, 2008 at 04:54 PM Do you have an IDE CDrom or DVDrom drive? possibly in BIOS? If you don't you could destroy data on it.How do you know about this?

The diagnostic program is self-documented and can be run only from DOS (not virtual DOS on OS/2 or DOS under Microsoft Windows). On the Primary IDE port, you probably should arrange the drive with your OS (the one you boot from) as the Master of that port, and the second unit as the If I were you, I would do this plan. >As suggested by OldGrayGary, don't share the dial-up. >Replace the cable with an 80 connector cable. Another thing you could try is to go into Device Manager and "remove" the whole IDE controller that the primary and secondary IDE controllers branch from, and see if Windows has

Best answer PaperdocJul 29, 2012, 11:36 AM Since this is an older computer with IDE ports, just how old is it? After you boot from the floppy disk, type the command Fdisk /mbr. So your best-choice replacement parts for Win98 era hardware are the ones that are free, or nearly so. ---Ah, and one last thing: for you best chance to enter setup, try Take the cdrom drive out.

Thankyou I will look into buying a 80 Pin Conductor Cable. Use these instructions along with the User guide provided by your CD-ROM Manufacturer and your Operating Systems User guide to help resolve Software/Driver related installation problems. nadji99Jul 29, 2012, 4:26 AM canadian69 said: A motherboard will have an IDE controller with two channels (primary/secondary) each channel supports a maximum of 2 PATA (IDE) drives. To begin, select the Run command on the Start menu and launch the Registry Editor by typing Regedit.exe in the Open text box.

One should be set to master, the other to slave. #8 tazdevl, Oct 18, 2001 Frglss Golden Member Joined: Jun 4, 2000 Messages: 1,572 Likes Received: 0 There's also the POST does not recognize... solved I need help installing my new hard drive More resources See also solved Installing new SATA hard drive into an IDE PC solved Need help with installing an old hard Also - you can't share the Internet by rigging analog phone lines between several PCs!

Comments Facebook Linkedin Twitter More Email Print Reddit Delicious Digg Pinterest Stumbleupon Google Plus About Greg Shultz Greg Shultz is a freelance Technical Writer. If they're set to Auto then it should be able to find them. If you really suspect that the removal and reinstallation of the IDE controller driver is causing the problem, then your only avenue to fix the problem is to reinstall the operating